New functions
- Remote access via Gira S1 or ise smart connect KNX remote access
- Launching Gira X1 app => connection established automatically in the background
- No more complex VPN setup
- No configuration of customer router
- Solution to IPV6 issues.
- Dimming (RGBW)
- Absolute RGB dimming function with five favourite settings
- Absolute RGBW dimming function with five favourite settings
- Dimming (Tunable White)
- Absolute Tunable White dimming function with five favourite settings
- Air conditioner control for KNX gateways with five favourite settings
- RTC auxiliary unit for sauna function
- Audio control with media support and playlists
- Button (Press/Release)
- Press for on / release for off
- Press for off / release for on
- Demo mode:
- Key functions of the app can be experienced even without Gira X1 hardware
- Available for iOS and Android
- PIN protection for system menu
- System menu settings protected from unauthorised access
- Status view – folder view
- Functions with status display
- Diagnostic page
- Mandatory authentication with user name and password
General improvements
- Trades
- Room name added to functions
- Dimmer and dimmer (step size) functions consolidated
- Camera
- Function with and without password
- Start button removed
- Heating and cooling (On/Off)
- Ability to switch between heating and cooling mode in the Gira X1 app
- Change operating mode is no longer required field
- RTC auxiliary unit ON/OFF
- Signed and unsigned 32-bit value transmitter
- Value transmitter with keypad input for value range with more than three digits
- Value transmitter (all function templates)
- Timer available in the Gira X1 app
Errors corrected
- The scrolling functions of the value transmitter did not stop at the target value when operated quickly.
- Symbols selected in GPA were not displayed in the Gira X1 app in a few cases.
- After restarting X1, it was possible that the configuration of the Gira X1 app would not load.
- The heating function could no longer be used in the Gira X1 App outside of the incorrectly configured min./max. values.
- Logic functions are read from the bus even without activating the "read from the KNX bus" parameter
- The "Delete all data points" function is missing from the scene set.
Known errors
- The sending physical KNX address is missing in the line scan.
- Data point of the camera is additionally toggled during switch-off.
- The discharging function of the ETS has no effect on the additional physical addresses.
- The KNX group address data point time (DPT 10.001) is sent with a random day of the week.
To perform the update the Gira Project Assistant V 2.4 is required. It is recommended to always use the latest available GPA version. Please follow the instructions in the enclosed documentation.